Make this a sticky!

I think the jetting guide by Spanky should be made a sticky topic in an appropiate section on the board. Let me know if you all agree, I have it ready to fire if everyone feel's the same.

Agreed! 100%

I think you should be a sticky!!!

yea, that would make a good sticky

Definatly.

sounds good

hey gareth, what u kno about helmet painting, im going to redo mine with flat black (fmx look) with some of my own graphic ideas,)

but i dont kno what paint to use, nor should i prime it? etc etc

let me kno if you can

I can't remember making this topic a poll!

Anyway Adam, I'll have to be quick - it's bed time here lol. Give it a good sanding down after removing everything off it. I'm not too sure about primer with flat finishes to be honest. I'm actually preparing a helmet for painting at the moment, so I'll let you know how that goes.

I'll hit the board tomorrow with some information for you, I'm a bit too tired right now!

I think it should be made a sticky, but in the two strokes area.

kawasaki kid wrote:

I think it should be made a sticky, but in the two strokes area.

Why only 2-strokes? Last time I checked (about 2 hours ago while rejetting my bike) 4-strokes have carbs as well.

Also, Gareth I JUST noticed that you're no longer Flesh anymore

, what's up with that!?

Ok Adam, you're best using primer I would say. For the paint you can near enough use any kind, most of mine are water based.

You probably didn't notice Sven because I still have the same sig, the reason behind that was for people to still recognise me. I'm currently trying to get my old account back but with my new name on there instead. The name UrbanRacer is taken from the name I mad up for our airbrushing "company" which in full is UrbanRacer Designs, when I begin racing again it will be my main sponser only it will have the word "team" before it - which is quite funny when you initialise it lol - that's T.U.R.D for all the non spellers!

Anyway, hopefully Cody will allow my application for a new username under the old account.

Wow, Gareth is a NEWBIE.

Water based acrylics are very good these days, but I'd put a polyurethane top-coat on it for added toughness and washability.

BTW, Spanky's should definitely be a sticky, or a permanent fixture in the "HOW-TO" section.

Yah thats definitely a good idea...

Its nice to have and it would save space instead of having every new member post about jetting. They can just look at teh sticky...

Definatly keep Spankys guide a sticky. I keep his guide in my toolbox so i always know how to jet the Spanky way.